User's Manual

The power light located just above the barrel input on the rig, should be red when supplying
power. YI HALO draws approximately 50 watts when recording in 2.5K resolution. Under
typical operating conditions, a fully charged supplied portable battery will run YI HALO for
over 90 minutes.
2.1.1 Powering YI HALO with the Portable Battery
1. Long press the power button on the battery to turn it on.
2. Check the remaining battery charge by observing the status lights on the side of the
battery. 4 lights on indicates that the battery is fully charged.
3. Slide the battery into the compartment
4. Plug the power cord to connect the mobile battery with YI HALO.
Notes:
● Keep the battery in dry and cool place.
● When the battery is not in use for a long time, charge the battery once fully, and then
use it until it fully discharges again.
● Repeatedly charging and discharging the battery will eventually shorten its battery life.
2.1.2 Power YI HALO from a Power Outlet
1. Connect the power adaptor’s DC plug to the power terminal on the rig.
2. Connect the power cord to the power adaptor and plug it into a power outlet.