Use Manual

transmitting infrared or radio frequency signals, the indicator light will flash
once.
Distribution network：
Please tap the RESET button with a toothpick, and press it for no more than 1
second. After letting go, you will see the indicator light flashing, indicating that
it is in the state of receiving and distributing the network. At this time, you can
open the Easy Accusation mobile app to connect to the network. (If the
pressing time exceeds 4 seconds, it may cause the device to reset and lose
the previously stored data)
Indicator light:
The indicator light flashes when the network is configured. After the power is
normally connected to the network, the indicator light is always on. When
Instructions
AI Hub User Manual
Wiring diagramFixed installation method
SIEMENS
Place the desktop
Install the wall
Install the roof
When the HUB is normally used on the desk, please rotate the bottom fixing
plate counterclockwise to remove it and store it for later use.
The HUB can be fixed on the wall or on the top of the wall. The fixed type can
fix the fixed plate with expansion screws.
Before fixing, consider the power supply line in advance. The fixing angle of the
HUB is the same as the three screw holes, so when fixing it, for aesthetic
reasons, it can be adjusted to the ideal angle in advance.
Whether it is on a table or a fixed wall, please be sure to pay attention to the
hemispherical emitting area at the top of the HUB that can be transmitted to all
infrared remote control appliances in the room.
If an infrared device is used in the cabinet, you can insert the infrared emission
extension cord into any OUT port of the HUB, and then introduce the extension
cord's transmitter to the infrared device receiving window in the cabinet, and
test the infrared code sent by the mobile phone APP to receive normal Prevail.
Once the HUB is successfully connected to the network, we recommend that it
be powered on all the time. If the power is cut off, the mobile APP and Tmall
Genie smart speakers will not be able to control the smart devices at home.
Packing list
Specifications
Operating voltage
Rated current
Product size
Working temperature
Working environment humidity
IP rating
DC5V
≤100mA
110X112X50mm
-10 ℃ —— 55 ℃
≤95%RH，without condensation
IP20
Infrared emission ball
Indicator light
RESET
Temperature and humidity sensor
HUB×1 Install the fixing plate×1
USB charging cable×1 Charger×1