User's Manual
Table Of Contents
- G30 User Manual
- Product Overview
- Product specifications
- Instructions for use
- Start-up and setup process
- 3.2 Connection Diagram
- 3.3 Application note about SOS and recording function
- 3.4 Application Notes on ACC ON/OFF
- 3.6 MODE 2 and MODE 21 Operating Modes
- 3.7 Vehicle Guard Alarm and Low Battery Alarm
- 3.8 Device Photosensitive Alarm Description
- 3.9 Vehicle collision alarm parameter setting instructions
- 3.10 Vehicle acceleration/deceleration and sharp turning parameter settings
- 3.11 About time zone settings and related instructions
- 3.14 Common Query Commands
- 3.15 Common Setting Instructions
- Manage your device
- Cautions
3. Instructions for use
3.1. Start-up and setup process
After the device is connected to the vehicle power supply, the recommended
installation flowchart is as follows:
Note:
Fist Insert SIM, then turn power key on.
Please make sure the SIM with data service from your operator.
If your SIM card with a PIN code, please refer to your mobile phone user manual
to remove the PIN code.
Open the A case
waterproof cover
Insert the SIM card in the
direction shown, apply power
supply to the device, and turn
the key to ON position.
Check the LED status:
1. Red LED Blink: Network registered;
2. Red LED ON: Server connected.
3. Blue LED Blink: Searching for GPS Fixed.
4. Blue LED ON: GPS Fixed.
Note: LEDs will turn off after 5 minutes.
Login system using app or web, check the
status and the functions.
Assemble the cover
Place the device flat with the
GPS antenna facing the sky
and the wiring harness toward
the rear of the car.
END