User's Manual

When GPSGSE, 1 #, the following settings about angle increment and speed increment are valid
2 CARSET, A, B, C, D # instructions
A: Sharp turn ang
le: Degree
B: Average turn speed: KM
C: Rapid acceleration increment: KM
D: Rapid deceleration reduction: KM, default:
75,20,8,18
When GPSGSE, 0 #, the following settings about Gsensor are valid
1 GSENACC,A#
Used to set the sensitivity of device accelera
tion
events (A = 1
-6, Default: 5)
The following value indicates that the
acceleration event will be detected during the
time X (unit: S) from 0 to 100KM/H.
A = 1, X = 58; A = 2, X = 29; A = 3, X = 19; A = 4, X =
14;
A = 5, X = 11; A = 6, X = 9
2 Added GSENDIR, D # instructions
Used to set the coordinate system of the device
(D = 0
-15),
The default is D = 5: the GPS antenna is facing the
sky, and the cable is facing the rear of the car.
D = 7: GPS antenna is facing the sky, wire is facing
the front
D = 4; GPS antenna is facing the sky, wire is facing
to the left
D = 6; GPS antenna is facing the sky, wire is facing
to the right
3 Added GSENCAL, D # instructions
Used to calibrate equipment
When D = 1, the device will calibrate immediately
after receiving the
instruction
When D = 0, the device will be calibrated next
time after receiving the command
Note: It is recommended to adjust the coordinate
system under re
-calibration