User's Manual

Select “Use the following IP address”,
enter the static IP address ( a free IP
address in 192.168.1.0/24) in IP address
field, 255.255.255.0 in Subnet mask
field, and enter the IP address of your
default gateway in Default Gateway field.
Click “OK” to finish the configuration.
Launch a web brouser, such as Internet Explorer or Mozilla
Firefox.
In the Address field enter the Device’s IP Address
(192.168.1.253) and press the Enter key.
Enter the default user name of admin and password of admin in
the User Name and Password fields. Click “OK” to access the
Device’s Web GUI.
NOTE: The Device works in FIT AP Mode by default. You can go to
“Start Device Mode” to change the Device Mode to FAT AP Mode.
2. If there is DHCP server on the local area network, the Device will obtain an IP address automatically.
NOTE:
1. Please assign your computer a static IP address within the same range as the Device’s IP address (192.168.1.253 by default). See more on
Appendix: Computer Configuration.
Secure the Mounting Bracket to the ceiling tile
by using the Expansion Bolts. Then feed the
Ethernet cable through the 25 mm hole.
Place the mounting bracket in the
center of the ceiling tile. Mark the
mounting screw holes and 25 mm
hole for the Ethernet cable. Use a
drill bit to drill the screw holes, and
cut or drill the 25 mm hole for the
Ethernet cable feed.
Connect the Ethernet cable to the
Ethernet port of the Device.
Align the notch on the Device with the
notch on the mounting bracket.
Turn the Device clockwise untill it
locks into place.