User's Manual

UTT Technologies Chapter 6 Basic Setup
http://www.uttglobal.com Page 84
Chapter 6 Basic Setup
This chapter describes how to configure and use the basic features of the Device, which
include LAN interface settings, WAN interface settings, load balancing (only multi-WAN
products support it), DHCP and DNS features.
6.1 LAN Settings
This section describes the Basic > LAN page.
After you have configured the Internet Connection through the Quick Wizard, you can
modify the IP address and subnet mask of the LAN interface in this page. Also, you can
configure some other parameters, which include the IP Address 2, Subnet Mask 2, MAC
Address, Proxy ARP, and Mode. Obviously, you can directly configure the IP address
and Subnet Mask of the LAN interface in this page without using the Quick Wizard.
Figure 6-1 LAN Interface Settings
 IP Address: It specifies the IP address of the LAN interface.
 Subnet Mask: It specifies the subnet mask that defines the range of the LAN.
¾ Advanced Options: Click it to view and configure advanced parameters. In most
cases, you need not configure them.
 IP Address 2: It specifies the secondary IP address of the LAN interface.
 Subnet Mask 2: It specifies the secondary subnet mask that defines the range of the
secondary subnet.