User's Manual

UTT Technologies Chapter 5 System Status
http://www.uttglobal.com Page 77
Session up test
The Device has successfully established a session
whose name is test.
Assigned to port @answerIncomingCall:8012
The Device has successfully negotiated with the remote
dial-in device, and has assigned a port to the remote
device.
Call Connected
@_netiNetworkStateChanged:
6244, on line 1, on channel 0
The physical layer and data link layer connections have
been established, but IP still couldn¶t be used.
Incoming Call
@_netiNetworkStateChanged:
6187, on line 1, on channel 0
The Device received a call from a remote device.
Route Up ethX
The static routes bound to the specified physical
interface became active. (Usually due to that the
corresponding Internet connection became active.)
eth1: LAN; eth2~eth5: WAN1~WAN4.
Route Down ethX
The static routes bound to the specified physical
interface became inactive. ˄Usually due to that the
corresponding Internet connection became inactive.˅
NAT exceeded [IP Address]
The specified host has exceeded the maximum NAT
sessions limited by the Device. Usually due to that this
host is infected with a virus or it is using hacker attack
software. If the host is working properly, please increase
the maximum NAT sessions appropriately.
ARP exceeded [IP Address]
The APR request for the specified IP address has been
rejected due to the maximum ARP entries limit. If the
ARP table is full, any new ARP request packet to the
Device will be rejected and this log message generated.