User's Manual

UTT Technologies Chapter 4 Quick Wizard
UTT Technologies http://www.uttglobal.com Page 39
Figure 4-3 Choosing an Internet Connection Type
 PPPoE: Some DSL-based ISPs use PPPoE to establish Internet connections for
end-users. If you use a DSL line, check with your ISP to see if they use PPPoE, and
then select the PPPoE radio button.
 Static IP: If you are required to use a static IP address, select the Static IP radio
button.
 DHCP: If your ISP will dynamically assigns an IP address to the Device, select the
DHCP radio button. Most cable modem subscribers use this connection type.
¾ Back: Click it to go back to the previous page of the Quick Wizard.
¾ Select the PPPoE radio button, and then click the Next button to go to the next page
of the Quick Wizard to configure a PPPoE Internet connection on the WAN1
interface.
¾ Select the Static IP radio button, and then click the Next button to go to the next page
of the Quick Wizard to configure a static IP Internet connection on the WAN1
interface.
¾ Select the DHCP radio button, and then click the Next button to go to the next page of
the Quick Wizard to configure a DHCP Internet connection on the WAN1 interface.