User's Manual

UTT Technologies Chapter 2 Hardware Installation
UTT Technologies http://www.uttglobal.com Page 28
10Mbps or 100Mbps.
Figure 2-4 Connecting the U2000 to the LAN and Internet
3. Connecting the U2000 to the Internet
Connect the network cable provided by the manufacturer from the DSL, cable or fiber
optic modem to a WAN port of the U2000, see Figure 2-4. If you don¶t have a network
cable provided by the manufacturer, please use a standard network cable.
4. Powering On the U2000
Connect the supplied power cord to the power connector on the back panel of the U2000,
and then plug the other end of the power cord to a grounded power outlet, lastly turn on the
power switch on the back of the U2000.
Note
To prevent the U2000 from working abnormally or being damaged, make sure that the
power supply and connectivity are normal, and the power outlet is grounded properly
before powering on the U2000.
5. Checking the LEDs
The LEDs are located on the front panel of the U2000, see Figure 2-5. We divide the
LEDs into two groups:
Ɣ The first group includes four system LEDs on the left two columns, which indicate