User's Manual
UTT Technologies Appendix B FAQ
http://www.uttglobal.com Page 400
5. How to use CLI Rescue Mode
In most cases, the Device can normally boot or reboot in Normal Startup Mode. However,
sometimes you are unable to start the Device in Normal Startup Mode due to
configuration errors, forgetting the administrator password or other reasons. To solve this
problem, we provide Rescue Mode in the Device with ReOS 5.0 or a latter version.
After boot into Rescue Mode, the Device will run with factory default settings without
custom settings, so it will like a new device that KDVQ¶WEHHQ configured. In Rescue Mode,
it allows you to use any CLI command to perform any operation.
Note
Only the Device having a serial port supports Rescue Mode.
Here we take Windows XP for example to describe how to start the Device in Rescue
Mode. The operation steps are the following:
Step 1 Connect the RJ-45 connector of the supplied serial cable to the terminal port on
the Device, and the DB9 connector of the cable to an open COM port on your
PC.
Step 2 Click Start > Programs > Accessories > Communications > HyperTerminal,
the first screen that appears is the New Connection dialog box, see Figure
B-0-19; enter a name (rescue in this example) in the Name text box, and then
click OK button.
Note that if HyperTerminal is not installed, click
Start > Settings > Control
Panel > Add or Remove Programs > Add/Remove Windows Components >
Accessories and Utilities > Details >
Communications > Details, select the
HyperTerminal check box, and then click OK.