User's Manual

UTT Technologies Appendix B FAQ
http://www.uttglobal.com Page 394
Figure B-0-12 Reset to Factory Default Settings - Term9600
4-2 Case Two: Forget the administrator password
If you forget the administrator password, you can use the following two ways to reset the
Device to factory default settings. Note that only when the Device has a reset button, you
can use the first way; and only when the Device has a terminal port, you can use the
second way.
¾ The first way: Reset the Device to factory default settings via Reset Button.
The operation is as follows: While the Device is powered on, use a pin or paper clip to
press and hold the Reset button for more than 5 seconds, and then release the button.
After that, the Device will restart with factory default settings.
¾ The second way: Reset the Device to factory default settings via Hyper
Terminal.
The operation steps are the following:
Step 1 Connect the RJ-45 connector of the supplied serial cable to the terminal port on
the Device, and the DB9 connector of the cable to an open COM port on your
PC.