User's Manual

UTT Technologies Appendix B FAQ
http://www.uttglobal.com Page 386
2. How to connect the Device to the Internet using
Static IP
Step 1 Please make sure the Internet connection is normal. You may use your PC to
test.
Step 2 Connect a network cable from the network device provided by your ISP to a
WAN port of the Device.
Step 3
Configure the static IP Internet connection related parameters in the
Basic >
WAN
page or through the
Quick Wizard
. Refer to
section 6.2.2.2 Static IP
Internet Connection Settings
for more information.
Step 4 After you finish configuring the static IP Internet connection, you may go to the
Status > Route Stats page to view the related route information in the Routing
Table, such as the Gateway IP Address provided by your ISP, Flag (N should
appear, which means NAT is enabled on the route), and so on, see Figure B-0-4
Figure B-0-4 Routing Table - Example 2
Step 5 Configure the LAN hosts according to the steps described in Appendix A How
to configure your PC.