User's Manual
UTT Technologies Chapter 13 System
http://www.uttglobal.com Page 374
13.5 Remote Admin
This section describes System > Remote Admin page.
As the Device has built-in firewall function, it will block all requests initiated from the
Internet by default. To remotely configure and manage the Device via Internet, you should
enable the HTTP remote management.
Figure 13-11 Remote Admin Settings
HTTP: It allows you to enable or disable HTTP remote management. Select this
check box to enable HTTP remote management via Internet. When accessing the
Device from Internet, you will enter http:// and enter the Device's WAN IP address,
followed by a colon (:) and the port number. For example, if the WAN IP address is
218.21.31.3 and port number is 8081, enter http://218.21.31.3:8081
in your browser
URL field.
Port: It specifies the port number for HTTP remote management. The default value is
8081. Note: If the port value is changed to 80, the system will automatically create
one port forwarding rule: protocol is TCP and port is 80; and you can go to the NAT >
Port Forwarding page to view it in the Port Forwarding List. In this case, it will
cause conflict if you add a new port forwarding rule for a LAN Web server.
¾ Save: Click it to save the remote admin settings.
Note
1. You can find WKH'HYLFH¶V:$1,3DGGUHVVIURPWKHWAN List in Basic > WAN page.
2. To ensure security, it is strongly recommended that you GRQ¶t enable HTTP remote
management unless necessary. If you are sure to enable it, you had better go to the
System > Administrator page to change the default password.
3. If the Internet connection has a dynamic IP address, you had better enable DDNS in
the Advanced > DDNS page, so you may use a fixed domain name to manage the