User's Manual

UTT Technologies Chapter 2 Hardware Installation
UTT Technologies http://www.uttglobal.com Page 23
Chapter 2 Hardware Installation
This chapter describes how to install the UTT products, which include UTT 2512, U2000.
2.1 Installation Requirements
1. A standard 10/100M or 10/100/1000M Ethernet network.
2. Each LAN PC needs an Ethernet card that works well.
3. TCP/IP should be installed on each PC properly.
4. You should have a DSL modem, cable modem or fiber optic modem.
5. If you will use a PPPoE Internet connection to access the Internet, you should have a
login name and password provided by your ISP.
2.2 Installation Procedure
Please make sure that the Device is powered off before installing it. The installation
procedures of UTT products are very similar, which include the following steps in general.
Step 1 Select a proper location to install the Device. You can install the Device install
the Device in a 19-inch standard rack; or on a level surface such as a desktop
or shelf if you don¶t have a 19-inch standard rack.
Step 2 Connect the Device to the LAN, that is, connect the PC or switch on your LAN
to a LAN port of the Device.
Step 3 Connect the Device to the WAN, that is, connect your DSL, cable or fiber optic
modem to a WAN port of the Device.
Step 4 Power on the Device. Note: Before powering on the Device, make sure that the
power supply and connectivity are normal, and the power outlet is grounded
properly.
Step 5 Check the LEDs on the front panel of the Device to see whether the Device is
working well or not.
The following sections describe the installation procedure, network connection diagram,
and LEDs status of each model respectively.