User's Manual

UTT Technologies Chapter 12 Security
http://www.uttglobal.com Page 359
12.8 Schedule
This section describes the Security > Schedule page.
12.8.1 Introduction to Schedule
The schedule feature lets you define schedules that can be applied to various time-related
features, e.g., dial schedule, rate limit rule, access control
rule, etc. The schedule is
identified by a name and then referenced by a function, so that those time restrictions are
imposed on the function itself.
A schedule consists of a start date, an end date, and optional time periods (up to eight).
The Start Date and End Date specify when the schedule begins and ends. If exceed the
specified range, the schedule will be of no effect. If both of them are set to 1990-1-1, the
schedule will be in effect forever. The time periods (Period 1-8) specify further constraints
of active time by the days of the week, daily start time and daily end time.
Note
To ensure that the schedules take effect at the desired time, you should synchronize
the system clock in the System > Time page.