User's Manual

UTT Technologies Chapter 12 Security
http://www.uttglobal.com Page 352
the Security > Firewall page or rate limit rule in the QoS > Rate Limit Rule page. If
you actually want to delete it, please remove all the references firstly.
12.6.4 How to Add the Address Groups
If you want to add one or more address groups, do the following:
Step 1 Go to the Security > Address Group page, and then click the New button or
select the Address Group Settings tab to go to the setup page.
Step 2 Specify the Name of the address group.
Step 3 Select the network zone from the Zone drop-down list.
Step 4 Add IP addresses to the group. There are two methods to add them.
1) Method One: Select the New radio button, enter the start and end IP
addresses in the Start Address and End Address text boxes, and then
click ==> to move the new address range to the Address Members list
box. You can continue to add another address ranges if needed.
2) Method Two: Select the Existing radio button, select one or more
configured address groups, and then click ==> to move the selected
address groups to the Address Members list box.
Step 5 Click the Save button to save the settings. You can view the address group in
the Address Group List.
Step 6 If you want to add another new address group, please repeat the above steps.
12.6.5 How to Edit an Address Group
If you want to modify a configured address group, do the following:
Step 1 Go to the Security > Address Group page.
Step 2 Click the Edit hyperlink of the address group in the Address Group List to go
to the setup page.
Step 3 Modify the address members as required. There are two cases:
1) If you want to modify an address range, select the address range in the
Address Members list, click <== to move it from the Address Members