User's Manual

UTT Technologies Chapter 12 Security
http://www.uttglobal.com Page 342
12.4 Domain Filtering
This section describes the Security > Domain Filtering page.
12.4.1 Domain Filtering Settings
Figure 12-25 Domain Filtering Settings
Enable Domain Filtering: It allows you to enable or disable domain filtering. If you
select the check box to enable domain filtering, the configured domain filtering entries
will take effect. Else, the domain filtering entries will be of no effect.
Filtering Mode: It specifies the mode of domain filtering. There are two available
options:
Ɣ Only Block Domain Names in Domain Name List: It indicates that the Device
will block the LAN users from accessing the domain names in the Domain Name
list, but allow the users to access any other domain names.
Ɣ Only Allow Domain Names in Domain Name List: It indicates that the Device
will allow the LAN users to access the domain names in the Domain Name list,
but block the users from accessing any other domain names.
Domain Name List: It specifies the domain names that will be blocked or allowed
according to the Filtering Mode. You can create up to 100 domain names in the list.