User's Manual

UTT Technologies Chapter 12 Security
http://www.uttglobal.com Page 328
Also, you can directly specify the source or destination IP addresses, or services of
access control rules in this page. The following describes the definitions of a rule¶s
parameters.
Figure 12-10 Access Control Rule Settings
 Action: It determines the action of the access control rule. There are two available
options:
Ɣ Allow: It indicates that the Device will allow the packets that match the rule to
pass, that is, the Device will forward these packets.
Ɣ Deny: It indicates that the Device will deny the packets that match the rule to
pass, that is, the Device will drop these packets.
 Schedule: It specifies a schedule to restrict when the access control rule is in effect.
The default value is Always, which means the access control rule is in effect always.
Note that after the selected schedule has expired, the rule will be in effect always.
 Description: It specifies the description of the access control rule. It is usually used
to describe the purpose of the rule.