User's Manual

UTT Technologies Chapter 12 Security
http://www.uttglobal.com Page 322
Figure 12-8 IP/MAC Binding List - Example Three
12.2.6.3 How to Configure Internet Blacklist
If you want to configure an Internet blacklist, do the following:
Step 1 Go to the Security > IP/MAC Binding page, and then click the New button or
select the IP/MAC Binding Settings tab to go to the setup page.
Step 2 Specify the illegal users by creating the IP/MAC bindings. There are three
methods:
1) Method One: Bind each illegal user¶s IP address to a MAC address which
is different from any LAN host¶s in the IP/MAC Binding List. Refer to
section 12.2.2 IP/MAC Binding Settings for detailed operation.
2) Method Two: Bind an IP address which is different from any LAN host¶s to
each illegal user¶s MAC address in the IP/MAC Binding List.
3) Method Three: Add these users¶ IP and MAC address pairs in the IP/MAC
Binding List. Unselect each IP/MAC binding¶s Allow Internet Access
check box respectively, then the matched users can not access the Device
and Internet.
Step 3 Select the Allow Undefined LAN PCs check box to allow all the undefined
users to access the Device and Internet.
For example, if you want to block a LAN user with IP address 192.168.16.68 and MAC
address 0015c5674109 from accessing the Device and Internet, you can add the
corresponding IP/MAC binding in the IP/MAC Binding List. And then unselect the
binding¶s Allow Internet Access check box to block the user¶s access to the Device and
Internet,
see Figure 12-9.