User's Manual

UTT Technologies Chapter 10 QoS
http://www.uttglobal.com Page 266
10.4 P2P Rate Limit
This section describes the QoS > P2P Rate Limit page.
P2P rate limit feature is specially designed for P2P application. The P2P rate limit has the
highest priority, that is, even if you have created rate limit rules for some LAN users in the
QoS > Rate Limit Rule page, the P2P traffic of these users is still restricted by P2P rate
limit settings. Using P2P rate limit, you can effectively reduce network congestion caused
by the usage of P2P applications without the expense of the other LAN users¶ traffic and
bandwidth.
Figure 10-4 P2P Rate Limit Settings
 Enable P2P Rate Limit: It allows you to enable or disable P2P rate limit. If you want
to enable P2P rate limit, please select this check box. P2P applications include Bit
Spirit, Bit Comet, Thunder, Tuotu, and so on.
 Max. Tx Rate: It specifies the maximum upload rate of the P2P traffic.
 Max. Rx Rate: It specifies the maximum download rate of the P2P traffic.
 Rate Limit Mode: It specifies the mode by which the Device will limit the maximum
Tx/Rx rate of the LAN hosts.
Ɣ Each: If you select this radio button, the Tx/Rx rate of each LAN host¶s P2P
traffic can reach the value specified by the Max. Tx/Rx Rate at most.
Ɣ Share: If you select this radio button, the total Tx/Rx rate of all the LAN hostV¶
P2P traffic can reach the value specified by the Max. Tx/Rx Rate at most.