User's Manual
UTT Technologies Chapter 10 QoS
http://www.uttglobal.com Page 264
view, modify or delete address groups.
¾ Edit Service Group: Click it to go to the Security > Service Group page to add,
view, modify or delete service groups.
¾ Save: Click it to save the rate limit rule settings.
Note
If the sum of specified Min. Tx/Rx Bandwidth LVODUJHUWKDQWKH,QWHUQHWFRQQHFWLRQ¶V
Uplink/Downlink Bandwidth (configured in the Basic > WAN page), the Device
cannot guarantee the specified hosts or applications with minimum upload/download
bandwidth.
10.3.2 Rate Limit Rule List
Figure 10-3 Rate Limit Rule List
¾
Add a Rate Limit Rule: If you want to add a new rate limit rule, click the New button
or select the Rate Limit Rule Settings tab to go to the setup page, and then
configure it, lastly click the Save button.
¾ Enable a Rate Limit Rule: The Enable check box is used to enable or disable the
corresponding rate limit rule. The default value is selected, which means the rate limit
rule is in effect. If you want to disable the rate limit rule temporarily instead of deleting
it, please click it to remove the check mark.
¾ View Rate Limit Rule(s): When you have configured some rate limit rules, you can