User's Manual

UTT Technologies Chapter 10 QoS
http://www.uttglobal.com Page 262
Figure 10-2 Rate Limit Rule Settings
 Source: It specifies the IP addresses of the LAN hosts to which the rate limit rule
applies. There are two available options:
Ɣ Addresses: Select it to enter the start and end addresses in the associated text
boxes.
Ɣ Address Group: Select it to choose an address group from the associated
drop-down list. By default, the Address Group radio button is selected, and its
value is Any Address.
 Destination Address Group: It allows you to select an address group to specify the
destination IP addresses of the traffic to which the rate limit rule applies.
 Min. Tx Bandwidth: It specifies the guaranteed upload bandwidth allocated to the
LAN hosts or applications that match the rate limit rule. Note that you can set the Min.
Tx Bandwidth, Min. Rx Bandwidth, Max. Tx Bandwidth and Max. Rx Bandwidth
through two ways.
z Enter a value in the associated text box. If you GRQ¶t want to specify a bandwidth,
please enter 0.
z Select an option from the associated drop-down list. If you don¶t want to specify a