User's Manual

UTT Technologies Chapter 9 PPPoE Server
http://www.uttglobal.com Page 241
 Tx. Traffic: It specify the max Tx. Traffic of the PPPoE account. The device will
accumulate the upload traffic of the PPPoE account, once the accumulative upload
traffic reaches the Tx. Traffic, the account cannot be used because it¶s been disabled
by the UTT device. 0 means no limit for upload traffic.
 Rx. Traffic: It specify the max Rx. Traffic of the PPPoE account. The device will
accumulate the download traffic of the PPPoE account, once the accumulative
download traffic reaches the Rx. Traffic, the account cannot be used because it¶s
been disabled by the UTT device. 0 means no limit for download traffic.
Note
Before the accumulative upload/download traffic reaches the Tx./Rx. Traffic, if you have
also set the PPPoE Account Expiration Notice(refer to section 9.7 PPPoE Account
Expiration Notice for more information), the device will push a notice to the user. If the
user decide to renew the account(Accounting Mode is By Traffic), the Administrator should
set the Tx. Traffic and Rx. Traffic to new value.
9.4 PPPoE IP/MAC Binding
In the PPPoE > PPPoE IP/MAC > IP/MAC Binding Settings page, you can create a
binding by mapping a static IP address to a host¶s MAC address, and then the PPPoE
server will always assign this IP address to the specified host.
9.4.1 PPPoE IP/MAC Binding Settings
Figure 9-11 PPPoE IP/MAC Binding Settings
 IP Address: It specifies the IP address for the PPPoE IP/MAC binding. The PPPoE