User's Manual

UTT Technologies Chapter 9 PPPoE Server
http://www.uttglobal.com Page 235
reaches the specified megabytes. Refer to section 9.3.4 PPPoE Account Billing
for more information.
 Max. Sessions: It specifies the maximum number of PPPoE sessions that can be
created by using the current PPPoE account.
 Account/MAC Binding: It specifies the type of PPPoE account and MAC address
binding. The available options are None, Auto and Manual.
Ɣ None: If you don¶t want to create account/MAC binding for the current PPPoE
account, select this option, then a PPPoE client with any MAC address can use
the current PPPoE account to dial up.
Ɣ Auto: If you want to create account/MAC binding for the current PPPoE account
automatically, select this option. That is, the Device will automatically bind the
PPPoE account to the MAC address of the user who uses this account to
establish a PPPoE session firstly. After that only this user can use the account.
Ɣ Manual: If you want to create account/MAC binding for the current PPPoE
account manually, select this option, and configure up to four MAC addresses
that are bound to the account. Then only the users with one of these MAC
addresses can use the account.
 MAC Address: It specifies the MAC address that is bound to the current PPPoE
account. If you select Manual from the Account/MAC Binding drop-down list, this
parameter will be displayed. In this case, you should enter a MAC address that is
bound to the account in the text box.
 MAC Address 2, MAC Address 3, and MAC address 4: It specifies another three
MAC addresses that are bound to the current PPPoE account. If you select Manual
from the Account/MAC Binding drop-down list, you can configure more than one
MAC address (up to four) if needed.
 Account/IP Binding: It specifies a static IP address that is assigned to the user who
uses the current PPPoE account. It must be a valid IP address in the range of
address pool configured in the PPPoE > Global Settings page.
¾ Save: Click it to save the PPPoE account settings.
Note
1. If you want to assign a static IP address to the user that uses a PPPoE account to
establish a PPPoE session, you should enter the IP address in the Account/IP
Binding text box, and should set the Max. Sessions to 1.