User's Manual

UTT Technologies Chapter 9 PPPoE Server
http://www.uttglobal.com Page 231
 Enable PPPoE Server: It allows you to enable or disable PPPoE server. If you want
to enable PPPoE server on the Device, please select this check box. Only after you
have enabled PPPoE server, you can configure the other parameters in this page.
 Start IP Address: It specifies the starting IP address that is assigned by the PPPoE
server.
 Number of Addresses: It specifies the maximum number of IP addresses that can
be assigned to the PPPoE clients. The addresses can be assigned dynamically or
manually by the PPPoE server.
 Primary DNS Server: It specifies the IP address of the primary DNS server that is
available to a PPPoE client.
 Secondary DNS Server: It specifies the IP address of the secondary DNS server
that is available to a PPPoE client.
¾ Advanced Options: Click it to view and configure advanced parameters. In most
cases, you need not configure them.
 PPP Authentication: It specifies the PPP authentication mode by which the PPPoE
server authenticates a PPPoE client. The available options are NONE, PAP, CHAP
and Either. In most cases, please leave the default value of Either, which means that
the Device will automatically choose PAP or CHAP to authenticate the PPPoE client.
 Max. Sessions: It specifies the maximum number of PPPoE sessions that can be
created on the Device. The maximum value of Max. Sessions depends on the
specific product model.
¾ Save: Click it to save the PPPoE server global settings.
9.2.2 Internet Access Control
Figure 9-3 Internet Access Control Settings
 Only Allow PPPoE Users: It allows you to enable or disable Only Allow PPPoE
Users, that is, only the PPPoE dial-in users can access the Internet through the
Device. If you want to only allow the PPPoE dial-in users to access the Internet