User's Manual
UTT Technologies Chapter 9 PPPoE Server
http://www.uttglobal.com Page 230
9.1.4 PPPoE Session Termination
After a session is established, either the server or client may send a PADT (PPPoE Active
Discovery Terminate) packet at anytime to indicate the session has been terminated. The
PADT packetΒΆs SESSION-ID must be set to indicate which session is to be terminated.
Once received a PADT, no further PPP packets (even normal PPP termination packets)
are allowed to be sent using the specified session. A PPP peer should use the PPP
protocol itself to terminate a PPPoE session, but can use the PADT packet to terminate
the PPPoE session if PPP cannot be used.
9.2 PPPoE Server Settings
The UTT Series Security Firewalls support PPPoE server to allow LAN hosts acting as the
PPPoE clients to dial up to the Device.
The UTT Series Security Firewalls provide rich PPPoE server features, which include
PPPoE server global settings, PPPoE account settings, static and dynamic address
allocation, PPPoE account and MAC address binding, PPPoE account and IP address
binding, PPPoE IP/MAC binding, PPPoE status viewing, and so on.
9.2.1 PPPoE Server Global Settings
Figure 9-2 PPPoE Server Global Settings