User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 190
Ɣ Every DHCP address pool¶s number of addresses is 253, which is the maximum
number of valid addresses in each subnet where the client hosts reside.
Ɣ Every DHCP address pool¶s lease time is 3600 seconds, primary and secondary DNS
VHUYHUV¶ IP addresses are 202.96.209.6 and 202.96.199.133.
Ɣ Their relay agent IDs are Test_Relay1, Test_Relay2 ... Test_Relay10 respectively,
which are in ASCII format.
Note that you also should create ten static routes whose destination networks are the
subnets where the client hosts reside. For more information about static route, please
refer to section 7.1.1 Static Route.
For those DHCP relay agent Devices, the DHCP relay agent settings are as follows:
Ɣ Every DHCP relay agent is applied on the LAN interface.
Ɣ Every DHCP relay agent¶s DHCP Server 1 is 200.200.200.254.
Ɣ Every DHCP relay agent¶s Option is insert.
Ɣ Their Relay Agent IDs are Test_Relay1, Test_Relay2 ... Test_Relay10 respectively,
which are in ASCII format.
Note that since the DHCP server uses the relay agent ID to distinguish each address pool,
we need set Option to insert for each relay agent. The DHCP relay agent will insert relay
agent ID before forwarding a client-originated DHCP message; thus the DHCP server can
select a matched address pool according to the relay agent ID to assign an address to the
requesting client.
2. Network Topology