User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 187
Figure 7-45 DHCP Relay Agent Settings - Example
Step 3 Select LAN from the Interface drop-down list.
Step 4 Select the Enable DHCP Relay Agent check box.
Step 5 Enter 200.200.200.254 in the DHCP Server 1 text box. Leave the default
values for the other parameters.
Step 6 Click the Save button to save the settings. Till now you have finished
configuring the DHCP relay agent, and then you can view its configuration and
status in the DHCP Relay Agent List.
7.8.7.4 Configuration Example for the Raw Option
1. Requirements
In this example, we need to create a raw option whose option name is ven_inf, option
code is 43 (that is, vendor-specific information) and option value is Test in ASCII format.
And it is applied on the LAN interface.
2. Configuration Procedure
Step 1 Go to Advanced > DHCP page, and select the Raw Option radio button.
Step 2 Select the Raw Option Settings tab to go to the setup page, see the following
figure.