User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 180
1. Network Requirements
In this example, the Device acts as a DHCP server to dynamically assign the IP addresses
to the clients that reside on the same subnet. The Device¶s LAN interface IP address is
192.168.16.1/24.
We need to create two address pools (pool1 and pool2). The pool1¶s address range is
from 192.168.16.2/24 to 192.168.16.101/24, primary and secondary DNS servers IP
addresses are 202.96.209.5 and 202.96.199.133, domain name is utt.com.cn and lease
time is 3600 seconds. And it uses Device¶s LAN IP address (that is, 192.168.16.1/24) as
the default gateway address. Leave the default values for the other parameters.
The pool2¶s address range is from 192.168.16.102/24 to 192.168.16.254/24 and lease
time is 7200 seconds. The pool2¶s primary and secondary DNS servers, domain name,
and default gateway IP address have the same values with pool1¶s.
Besides, we need to create a DHCP manual binding to the host that needs a static IP
address. The host¶s MAC address is 000795a81c3d, client ID is 01000795a81c3d which
is formed by concatenating the media type and MAC address, and host name is test. The
host wants to use 192.168.16.10/24 as its IP address and binding1 as its user name. It is
obvious that the host belongs to the pool1.
2. Network Topology
LAN
DHCP Client DHCP Client
DHCP Client
DHCP Client
DHCP Server
Figure 7-37 Network Topology where DHCP Server and Clients on Same Subnet
3. Configuration Procedure
1
˅
Configuring DHCP Server Global Parameters
Step 1 Go to the Advanced > DHCP page, and then select the DHCP Server radio
button to go to the DHCP Server page.
Step 2 Select the Global Settings tab to go to the setup page.
Step 3 Select the Enable DHCP Server check box, see the following figure.