User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 167
belongs.
 User Name: It specifies a unique name for the DHCP manual binding. It is used to
identify the host that want to be assigned a static IP address. It should be between 1
and 31 characters long.
 IP Address: It specifies the IP address for the DHCP manual binding. It must be a
valid IP address of the related address pool. The requesting host that matches the
manual binding will be assigned this specified address.
 MAC Address: It specifies the MAC address of the DHCP client.
 Client ID: It specifies the Client ID of the DHCP client. There are three types of
formats.
Ɣ hex: It is used to specify a hexadecimal string. It should be between 1 and 25
characters long.
Ɣ ascii: It is used to specify an ASCII character string. It should be between 1 and
27 characters long.
Ɣ ip: It is used to specify an IP address.
 Remote ID: It specifies the Remote ID of the DHCP client. There are three types of
formats.
Ɣ hex: It is used to specify a hexadecimal string. It should be between 1 and 25
characters long.
Ɣ ascii: It is used to specify an ASCII character string. It should be between 1 and
27 characters long.
Ɣ ip: It is used to specify an IP address.
 Host Name: It specifies the local host name of the DHCP client. It should be between
1 and 31 characters long.
¾ Save: Click it to save the DHCP manual binding settings.
¾ Show ARP Table: Click it to display the hostV¶ dynamic ARP information learned by
the LAN interface. Note: It will only display dynamic ARP information, but not display
static ARP information (that is, the IP and MAC address pairs have been bound
manually).