User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 165
Figure 7-26 DHCP Server Global Settings
 Enable DHCP Server: It allows you to enable or disable DHCP server. If you want to
enable DHCP server on the Device, please select this check box.
 DHCP Ping Packets: It specifies the maximum number of ping packets which is used
by ICMP address conflict detection method. It should be between 0 and 10, and the
default value is 2. If you want to turn off ICMP detection feature, please set its value to
0.
 DHCP Ping Timeout: It specifies the amount of time (in milliseconds) that the DHCP
server waits before timing out a ping packet. It should be between 500 and 10000
milliseconds, and the default value is 500 milliseconds.
¾ Save: Click it to save the DHCP server global settings.
Note
For more information about ICMP address conflict detection method, please refer to
section 7.7.2.1.1 Address Conflict Detection Method.
7.8.4.2 DHCP Manual Binding List
Figure 7-27 DHCP Manual Binding List
¾
Add a DHCP Manual Binding: If you want to add a new DHCP manual binding, click
the New button or select the Manual Binding Settings tab to go to the setup page,
and then configure it, lastly click the Save button.
¾ View DHCP Manual Binding(s): When you have configured some DHCP manual