User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 164
Step 4 In most cases, select the Enable PnP check box to enable PnP for the client.
Step 5 Specify the Request Mode and Required Response Mode if required.
Step 6 Specify the Client ID if required.
Step 7 In most cases, select the Allow AutoIP check box to allow the DHCP client to
use AutoIP.
Step 8 Click the Save button to save the settings. Till now you have finished
configuring the DHCP client applied on the specified interface, and then you
can view the related configuration and status in the DHCP Client List.
Note
If you want to disable DHCP client on a physical interface, please click its Edit
hyperlink in the DHCP Client List, and then unselect the Enable DHCP Client check
box, lastly click the Save button.
7.8.4 DHCP Server
Go to the Advanced > DHCP page firstly, and then select the DHCP Server radio button
(see the following figure) to go to the DHCP Server page, which includes the Global
Settings, Manual Binding List, Manual Binding Settings, Address Pool List and
Address Pool Settings subpages.
Figure 7-25 Select DHCP Server
7.8.4.1 DHCP Server Global Settings