User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 139
7.4 Plug and Play
This section describes the Advanced > Plug and Play page.
7.4.1 Introduction to Plug and Play
Plug and Play is a new feature of UTT series security firewalls. If you enable plug and play
feature on the Device, the LAN users can access the Internet through the Device without
changing any network parameters, no matter what IP address, subnet mask, default
gateway and DNS server they might have. Obviously, this feature can greatly facilitate the
users. As this feature is suitable for hotel network, we also call it hotel special version.
7.4.2 Enable Plug and Play
Figure 7-14 Enable Plug and Play
 Enable Plug and Play: It allows you to enable or disable plug and play. By default it
is disabled. If you select the check box to enable this feature, no matter what IP
address, subnet mask, default gateway and DNS server the LAN users might have,
they are able to access the Internet through the Device.
¾ Save: Click it to save your settings.
Note
1. The LAN hosts basic TCP/IP parameters (including IP address, subnet mask,
gateway IP address, and DNS server IP address) should be set properly; otherwise,
plug and play feature cannot act on those hosts.