User's Manual
UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 129
If the outbound interface is a dial interface, you should select the corresponding physical
interface from the Bind to drop-down list, but need leave the Gateway IP Address the
default value 0.0.0.0. In this case, the next hop IP address is assigned by a dial server
(e.g., PPPoE server).
For example, you want to create a CNC route PDB entry. The CNC Internet connection is
PPPoE connection (that is, the outbound interface is a dial interface), and the
corresponding physical interface is WAN2. Here you should select WAN2 from the Bind
to drop-down list, but need leave the Gateway IP Address the default value 0.0.0.0. The
next hop IP address is assigned by your IS3ΒΆs PPPoE server. The detailed settings are
shown in the following figure.
Figure 7-7 Static Route PDB Settings - Example Two
Step 5 Specify the priority and metric for the static route PDB entry as required. In
most cases, please leave the default values.
Step 6 Click the Save button to save the settings. You can view the static route PDB
entry in the Static Route List.
Step 7 If you want to add another new static route PDB entry, please repeat the above
steps.
Note
If you want to delete one or more static route PDB entries, select the leftmost check
boxes of them in the Static Route List, and then click the Delete button.
7.1.2.4 How to Update a System Default Static Route PDB
As mentioned earlier, if you want to update a system default static route PDB, please go to