User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 127
7.1.2.2 Static Route PDB Settings
Figure 7-5 Static Route PDB Settings
Because each static route PDB encapsulates many IP addresses and subnet masks, you
needn¶t configure the Destination IP and Subnet Mask when creating a static route PDB
entry as shown in Figure 7-5.
As a route PDB entry¶s Gateway IP Address, Bind to, Detection Interval, Priority and
Metric are the same with a static route¶s, please refer to section 7.1.1.3 Static Route
Setup for detailed description.
 Predefined: You should select a PDB option when creating a static route PDB entry.
The available options are TEL, CNC and ChinaMobile. Note that the TEL PDB
should be bound to a TEL connection, the CNC PDB should be bound to a CNC
connection, and the ChinaMobile PDB should be bound to a China Mobile
connection.
 Detection Interval: Its value should be 0 for a route PDB entry.
 Description: Its value is Routing PDB, which is provided by the system
automatically when creating a static route PDB.
 Save: Click it to save the static route PDB entry settings.
When you have created a route PDB entry here, the system will automatically create
many static routes that have the following characteristics:
z Their Destination IP and Subnet Mask are predefined by the route PDB.
z Each static route has same Gateway IP Address, Bind to, Detection Interval,
Priority and Metric, that is, the same with the route PDB. Note: As the Detection
Interval can only be set to 0 when creating the PDB entry, so each static route¶s
Detection Interval is 0.