User's Manual

UTT Technologies Chapter 7 Advanced Setup
http://www.uttglobal.com Page 124
Step 4 Specify the next hop IP address by the Gateway IP Address or Bind to.
If the outbound interface is a physical interface, you should specify the Gateway IP
Address, but may leave the Bind to blank. In this case, the Device will select an optimal
transmission path.
For example, a static route¶s destination network is 192.168.1.0/24, gateway IP address is
192.168.1.254, and the outbound interface is a physical interface. Here you should enter
192.168.1.254 in the Gateway IP Address text box, but may leave the Bind to blank. The
Device will select an optimal transmission path. The detailed settings are shown in the
following figure.
Figure 7-3 Static Route Settings - Example One
If the outbound interface is a dial interface, you should select the corresponding physical
interface from Bind to drop-down list, but need leave the Gateway IP Address the default
value 0.0.0.0. In this case, the next hop IP address is assigned by a dial server (e.g.,
PPPoE server).
For example, a static route¶s destination network is 218.19.213.45/24, the outbound
interface is a PPPoE dial interface, and the corresponding physical interface is WAN2.
Here you should select WAN2 from the Bind to drop-down list, but need leave the
Gateway IP Address the default value 0.0.0.0. The next hop IP address is assigned by
your IS3¶s PPPoE server. The detailed settings are shown in the following figure.