User's Manual

UTT Technologies Chapter 6 Basic Setup
http://www.uttglobal.com Page 114
6.3.7.4 The Configuration Steps of ID Binding
Step 1 Go to the Basic > Load Balancing > ID Binding page.
Step 2 Select the Enable ID Binding check box if needed.
Step 3 Click the Save button to save the ID binding settings.
6.3.8 Related Detection Route
When connection detection is enabled on an Internet connection (i.e., Detection Interval
is more than 0), the Device will automatically create a detection route for the connection to
ensure that the detection packets are forwarded through it. You can view the detection
route configuration in the Static Route List on the Advanced > Static Route page. Refer
to section 7.1.1.2 System Reserved Static Routes for more information about detection
routes.
Note
For a static IP or DHCP Internet connection, when its Detection Target IP is set to
Gateway IP Address, the system will directly use its default route to forward
detection packets to monitor the connection. That is, the default route also acts as a
detection route.