User's Manual

UTT Technologies Chapter 6 Basic Setup
http://www.uttglobal.com Page 113
configure detection related parameters and Weight for the selected connection. Then
continue to configure these parameters for other connection(s) one by one.
3. Go to the Basic > Load Balancing > Global Settings page to configure global
parameters as required.
4. Go to the Basic > Load Balancing > ID Binding page to enable ID binding feature if
needed.
6.3.7.2 The Configuration Steps of Connection Detection and
Weight
Step 1 Go to the Basic > Load Balancing page.
Step 2 Click the Edit hyperlink of an Internet connection in the Load Balancing List to
go to the Detection & Weight page.
Step 3 Configure the connection detection related parameters (Detection Target IP,
Detection Interval, Retry Times) and Weight for the selected Internet
connection as required.
Step 4 Click the Save button to save the detection and weight settings for the selected
Internet connection.
Step 5 If you want to configure the connection detection related parameters and
Weight for another Internet connection, please repeat the above steps.
6.3.7.3 The Configuration Steps of Load Balancing Global
Settings
Step 1 Go to the Basic > Load Balancing > Global Settings page.
Step 2 Specify the Detection Method as required.
Step 3 Specify the Load Balancing Policy as required.
Step 4 Specify the Load Balancing Mode as required. If you choose Partial Load
Balancing as Load Balancing Mode, you need move one or more Internet
connections from the Primary list box to the Backup list box according to
actual requirement. .
Step 5 Click the Save button to save the load balancing global settings.