User's Manual

UTT Technologies Chapter 6 Basic Setup
http://www.uttglobal.com Page 110
Backup list box is a backup connection. Refer to section 6.3.1.2 Load Balancing
Mode for more information.
 ==>: Select one or more Internet connections in the Primary list box, and then click
==> to move the selected connection(s) to the Backup list box.
 <==: Select one or more Internet connections in the Backup list box, and then click
==> to move the selected connection(s) to the Primary list box.
¾ Save: Click it to save the load balancing global settings.
Note
1. The WAN1 Internet Connection can only be located in the Primary list box, that is,
you cannot move it to the Backup list box.
2. If you change the Load Balancing Mode from Partial Load Balancing to Full Load
Balancing and click the Save button to save the change, the Device will
automatically move all the Internet connection(s) in the Backup list box to the
Primary list box.
3. If you move all the Internet connection(s) in the Backup list box to the Primary list
box and click the Save button to save change, or delete all the backup connections in
the Basic > WAN > WAN List page, the Device will automatically switch the Load
Balancing Mode from Partial Load Balancing to Full Load Balancing.
6.3.5 Detection and Weight Settings
Note
In the Basic > Load Balancing > Detection & Weight page, you can configure the
connection detection related parameters (Detection Target IP, Detection Interval,
Retry Times) and Weight for each Internet connection respectively. The operation is
as follows: Click the Edit hyperlink of an Internet connection in the Load Balancing
List to go to Detection & Weight setup page, and then configure those parameters
for the selected Internet connection, lastly click the Save button.