User's Manual

UTT Technologies Chapter 6 Basic Setup
http://www.uttglobal.com Page 99
Ɣ Disabled: Select it to disable the proxy ARP on the WAN interface.
Ɣ Enabled: Select it to enable the proxy ARP on the WAN interface.
Ɣ Nat: Select it to enable the NAT proxy ARP on the WAN interface.
 Mode: It specifies the speed and duplex mode of the WAN interface. The Device
supports five or six modes (Note that only the gigabit WAN interface supports
1000M-HD), which include Auto (Auto-negotiation), 100M-FD (100M Full-Duplex),
100M-HD (100M Half-Duplex), 10M-FD (10M Full-Duplex), and 10M-HD (10M
Half-Duplex) , 1000M-FD (1000M Full-Duplex). In most cases, please leave the
default value. If a compatibility problem occurred, or the network device connected to
the WAN interface doesn¶t support auto-negotiation function, you may modify it as
required.
¾ Save: Click it to save the DHCP Internet connection settings.
6.2.2.4 How to Delete the Internet Connection
Figure 6-8 Delete the Internet Connection
If you want to delete a configured Internet connection, go to the Basic > WAN > WAN List
page firstly, and then click Delete of the connection in the WAN List, see Figure 6-8. The
system will pop up a prompt dialog box, see Figure 6-9. Then click OK to delete the
connection, or click Cancel to cancel the operation.