User's Manual

UTT Technologies Chapter 6 Basic Setup
http://www.uttglobal.com Page 98
6.2.2.3 DHCP Internet Connection Settings
If your ISP automatically assigns an IP address, please select DHCP from the
Connection Type drop-down list. Then the following page will be showed.
Figure 6-7 DHCP Internet Connection Settings
 Connection Type: It specifies the type of the Internet connection. Here please select
DHCP.
 Uplink Bandwidth: It specifies the uplink bandwidth of the Internet connection, which
is provided by your ISP. You may ask the ISP about the uplink bandwidth.
 Downlink Bandwidth: It specifies the downlink bandwidth of the Internet connection,
which is provided by your ISP. You may ask the ISP about the downlink bandwidth.
 ISP: It specifies the Internet service provider by which the Internet connection is
provided.
 Primary DNS Server: It specifies WKH,3DGGUHVVRI\RXU,63¶VSULPDU\'16server. If
the Internet connection is refreshed, your ISP may update it to a new IP address.
 Secondary DNS Server: It specifies the IP address of your ISP¶s secondary DNS
server. If it is available, you may set it. Else, please leave it blank.
¾ Advanced Options: Click it to view and configure advanced parameters. In most
cases, you need not configure them.
 MAC Address: It specifies the MAC address of the WAN interface. In most cases,
please leave the default value.
 Proxy ARP: It allows you to enable or disable proxy ARP on the WAN interface. The
available options are Disabled, Enabled and Nat.