User's Manual
UTT Technologies Chapter 6 Basic Setup
http://www.uttglobal.com Page 93
using correct user name and password, you may try to use another mode.
DNS Server: It specifies the method by which you configure the DNS server(s). If you
know the local DNS server IP address, you may select Manual, then enter the DNS
server IP address in the Primary DNS server text box, and the secondary DNS
server IP address in the Secondary DNS Server if available. Else, please select
Auto, then the Device will automatically obtain the DNS server IP address.
Primary DNS Server: It specifies WKH,3DGGUHVVRI\RXU,63¶VSULPDU\'16server.
Secondary DNS Server: It specifies the IP address of your ISP¶s secondary DNS
server. If it is available, you may set it. Else, please leave it 0.0.0.0.
¾ Advanced Options: Click it to view and configure advanced parameters. In most
cases, you need not configure them.
PPP Authentication: It specifies the PPP authentication mode of the PPPoE
connection. The available options are NONE, PAP, CHAP and Either.
x PAP: Password Authentication Protocol.
x CHAP: Challenge Handshake Authentication Protocol.
x None: It means that there is no protocol will be used.
x Either: It means that the Device will automatically negotiate it with the peer
device.
Service Name: It specifies the service name provided by your ISP. In most cases,
please leave it blank. If you have any questions, please contact the ISP.
MRU: It specifies the largest packet size permitted for network receive. When dialing,
the Device will automatically negotiate it with the peer device. Unless special
application, please leave the default value of 1492 bytes.
Dial Type: It specifies the dial type of the PPPoE connection. The available options
are Always On, Manual and On Demand.
x Always On: If you want the Device to establish a PPPoE connection when
starting up and to automatically re-establish the PPPoE connection once
disconnected, select this option.
x Manual: If you want to dial and hang up a PPPoE connection manually, select
this option. In this case, you should dial and hang up manually in the WAN List in
the Basic > WAN page (see section 6.2.1.3).
x On Demand: If you want the Device to establish a PPPoE connection only when
it listens for packets destined for the Internet, select this option. In this case, the
Device will terminate the connection after it has been inactive for the period of
time specified by the Idle Timeout.