Safety Instructions
Table Of Contents
RF Exposure Information (SAR) :
This device meets the government's requirements for exposure to
radio waves. This device is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6 W/kg. *Tests for SAR are conducted
using standard operating positions accepted by the FCC with the
device transmitting at its highest certified power level in all tested
frequency bands.
Although the SAR is determined at the highest certified power level,
the actual SAR level of the device while operating can be well below the
maximum value. This is because the device is designed to operate at
multiple power levels so as to use only the poser required to reach the
network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
The highest SAR value for the device as reported to the FCC when
tested for use at he body is 1.42W/kg (Body-worn measurements differ
among devices, depending upon available enhancements and FCC
requirements.) While there may be differences between the SAR levels
of various devices and at various positions, they all meet the
government requirement. The FCC has granted an Equipment
Authorization for this device with all reported SAR levels evaluated as
in compliance with the FCC RF exposure guidelines. SAR
information on this device is on file with the FCC and can be found
under the Display Grant section of http://www.fcc.gov/oet/fccid after
searching on FCC ID: 2AH25T5940
For body worn operation, this device has been tested and meets the
FCC RF exposure guidelines for use with an accessory that contains no
metal and the positions the handset a minimum of 0 mm from the
body . Use of other enhancements may not ensure compliance with
FCC RF exposure guidelines. If you do not use a body-worn
accessory , position the handset a minimum of 0 mm from your body
when the device is switched on at its highest certified power level in all
tested frequency bands.


