User's Manual

Usermanual

Specification:
PairedwithRemoteControlModule:
1. RemoteControlModuleInstallation:




2. ReapplypowertotheExitButton.
3. PressandholdthebuttononthemoduleuntiltheredLEDcomeson,
thenrelease.
4. While the LED is illuminated, press the button on the remote con
trol, then LED will
blinkindicatingthecodeisbeingstored.
5. Theredledwillgoouttoindicatethesuccessfulprogramming.Upto5remotescanbe
paredwiththeonereceivebyfollowingtheaboveprocedure.
6. Todeleteallunits,pressandholdthebuttononthebackoftheboarduntiltheredLED
comeson.ContinuetoholdthebuttonuntiltheLEDgoesout.
Fig
ure5
Figure4
Whenextraremotecontrolisavailable,theremote
control module shall be inserted into the holes.
Insertthe6pinsofthemodule(Figure4)intothe
correctholesofboard(Figure3).

Figure3
OperatingVoltage
DC6V
OperatingCurrent(Max.) 15mAmax
StaticCurrent 0mA
OperatingFrequency
433.92MHz
ModulationMode ASK
ReadRange 10m
Numberofbutton 1
OperatingTemperature
‐20~60℃
OperatingHumidity 10~90%
Size 63*32*10.35mm