Slender Series 13.56 MHz Reader Product Name: Slender Series 13.56 MHz Reader Brand: Vitto Model: MW3D2-8N User Manual Manufacture: Shanghai Smarfid Security Equipment Co., Ltd.
Slender Series 13.56 MHz Reader Mounting: Recommendation: 1. Install the back plate on the wall as shown in the diagram below. 2. The cover shall clip on the upper edge the push in the bottom part as show in 1. Linear DC Power Supply; 2. 22AWG shielded cable; it’s required to do “one-point” ground. (As shown in the diagram) diagram. 3. Tighten the non-dropout screw, which located underneath of the reader to fix the reader and the back plate, installation is completed.
Slender Series 13.56 MHz Reader 1. This is a Slender Series 13.56 MHz Reader. When reader is powered up, the Green back will flicker for 5 seconds. The reader will beep once and the reader is in Ready mode. 2. Present the card. The Red LED will flicker once; buzzer will beep once. 3. When card is present and read by the reader, the card data will be transmitted to the controller.
Slender Series 13.56 MHz Reader FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
