User's Manual

Mifare Contactless Reader (MW3528) Operation Manual

ver1.0

Model：MW3528

General

This is a Mifare flash reader. When a card is being read by the reader, the reader will lit up.

Reader Start up

When reader power up, the reader will lit ON. The Red LED will blinks for 5 seconds. After 5 seconds, the reader

will ‘beep’ to indicate the start up procedures is finished.

Installation Diagram

1. The back part shall fit on the wall.

2. The cover shall clip on the upper edge of the back part first.

3. After, tighten the screw goes underneath of the reader to fix the reader with the back part.

Operating Specification:

Operating Voltage

9-13VDC

Typical read range

5cm

Operating current

120mA

Standard Color

Black

Operating Temperature

-20℃ - 60℃

Exterior dimension

150mm×53mm×25mm

PAGE 1
Mifare Contactless Reader (MW3528) Operation Manual ver1.0 Model：MW3528 General This is a Mifare flash reader. When a card is being read by the reader, the reader will lit up. Reader Start up When reader power up, the reader will lit ON. The Red LED will blinks for 5 seconds. After 5 seconds, the reader will ‘beep’ to indicate the start up procedures is finished. Installation Diagram 1. The back part shall fit on the wall. 2. The cover shall clip on the upper edge of the back part first. 3.
PAGE 2
SIEMENS Mifare Contactless Reader Operation Manual ver1.
PAGE 3
SIEMENS Mifare Contactless Reader Operation Manual ver1.0 FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; (2) This device must accept any interference received, including interference that may cause undesired operation.