User's Manual

Keypad & Proximity Reader Installation Manual
Brown Buzzer Buzzer input, active low
Grey Tamper Tamper output (open collector, Active low, max 100mA)
Purple Doorbell Door bell output (open collector, +5Vdc output ≤ 5mA)
Troubleshooting
Power & Testing
1. When reader is powered up, the blue LED will light up. The orange LED will flicker for 5
seconds. The reader will beep once for 1 second and the reader is in Ready mode.
2. Present the card. The orange LED will flicker once; the back lit will light for 5 seconds;
buzzer will beep once.
3. For keypad readers, the back light and the keypad numeral will light when the keypad is
pressed; the buzzer will beep once
Using the Configuration Card (For keypad readers only)
The default keypad format is “00”. The Configuration Card is required when the default
keypad format is not compatible with the controller.
1. When reader is powered up, the blue LED will light up. The orange LED will flicker for 5
seconds.
2. Present the Configuration Card for the required format. A 1-second beep indicates a
successful attempt. The new keypad format is saved.
Configuration cards are available for:
o 4 bits ○ Apollo 6 bits
o 8 bits ○ 26 bits (Fixed Facility Code 190)
Physical Dimension
Symptom Solution
o Disconnect the power and confirm that the power supply cable
is correctly connected (Refer to Wiring table)
No response when
power up
o Check the input voltage is sufficient (Refer to Specifications
table)
o Check the input voltage is sufficient ( Refer to Specifications
table)
Auto restart
o Verify that the format setting on the controller is the same as the
card format. Use approved card (known format and Facility
Code) to test
Card number not
read correctly
o Check that the shield cable is correctly connected to Chassis
Ground at ONE point only
o Check that Data 0 and Data 1 cable are correctly connected
(Refer to Wiring table).
Reader beeps but
no card data
o Check the input voltage at the card reader end is correct (Refer
to Specifications table)
o Verify that the buzzer cable is correctly connected (Refer to
Wiring table)
No buzzer sound
o Verify that the LED cable is correctly connected (Refer to Wiring
table)
Back lit error
o Use the default Configuration Card to reset to default setting