User's Manual

Slender Series 125 kHz Reader
Mounting:
1. Install the back plate on the wall as shown in the diagram below.
2. The cover shall clip on the upper edge the push in the bottom part as show in
diagram.
3. Tighten the non-dropout screw, which located underneath of the reader to fix the reader and
the back plate, installation is completed.
Specification:
Recommendation:
1. Linear DC Power Supply;
2. 22AWG shielded cable; it’s required to do “one-point” ground. (As shown in the diagram)
Wiring:
Input Voltage (at
Reader end)
DC5V~12V
Typical Read
range
> 6cm
Operating Current
100mA (max)
Maximum Cable
Length
150m
Operating
Temperature
-10ºC~70 ºC
Color
Label
Description
Red
+12V dc
Black
GND
Signal GND
Green
Data0
White
Data1
Wiegand Output data, D1
Blue
Green LED
Green LED control, active low