User's Manual

Manual
Bluetooth & Multi-technologies Reader User Manual
Mounting:
1. Install the metal plate on the wall with two or four screws, which depends on different kinds of
gang box being installed
.
2. The cover shall clip on the upper edge
 the push in the bottom part as show in
diagram
.
3. Tigh
ten the secure non-dropout screw, which located underneath of the reader to fix the
reader and the back plate
, installation is completed.
Specification:
Rec
ommendation:
1. Linear DC Power Supply;
2. 22AWG shielded cable; it’s required to do “one-point” ground. (As shown in the diagram)
Wirin
g:
Input Voltage (at
Reader end)
DC9V~15V
Typical Read
range
2~ 5cm
Operating Current
160mA (max)
Maximum Cable
Length
150m
Operating
Temperature
-30ºC~70 ºC
Number pad
format
4 bits burst by default
Color Description
Red Power Supply to the reader
Black Signal GND
Green Wiegand Output data, D0
White Wiegand Output data, D1
Yellow RED LED control, active low.
Blue Green LED control, active low
Brown Buzzer input, active low
Orange Tamper output (open collector, Active low, max 100mA)
Purple
Door bell output (open collector, +5Vdc output ≤ 5mA)