Shanghai Simcom GSM/GPRS+GPS module : User's Manual : Page 2

Smart Machine Smart Decision

SIM868_Hardware_Design_V1.00 2 2016-06-20

General Notes

SIMCom offers this information as a service to its customers, to support application and engineering efforts that

use the products designed by SIMCom. The information provided is based upon requirements specifically

provided to SIMCom by the customers. SIMCom has not undertaken any independent search for additional

relevant information, including any information that may be in the customer’s possession. Furthermore, system

validation of this product designed by SIMCom within a larger electronic system remains the responsibility of the

customer or the customer’s system integrator. All specifications supplied herein are subject to change.

Copyright

This document contains proprietary technical information which is the property of SIMCom Limited, copying of

this document and giving it to others and the using or communication of the contents thereof, are forbidden

of a patent or the registration of a utility model or design. All specification supplied herein are subject to change

without notice at any time.

Compliance Information

FCC Compliance Statement: This device complies with Part 15 of the FCC Rules . Operation is subject to the

following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept

any interference received, including interference that may cause undesired operation. This device must accept

any interference received, including interference that may cause undesired operation. Product that is a radio

transmitter is labeled with FCC ID.

FCC Caution

(1) Exposure to Radio Frequency Radiation. This equipment must be installed and operated in accordance with

provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation

distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other

antenna or transmitter. End-users and installers must be provided with antenna installation instructions and

transmitter operating conditions for satisfying RF exposure compliance.

(2) Any changes or modifications not expressly approved by the grantee of this device could void the user's

authority to operate the equipment.

(3) This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

(4) Changes or modifications to this unit not expressly approved by the party responsible for compliance could

void the user authority to operate the equipment.

(5) The modules FCC ID is not visible when installed in the host, or

(6) If the host is marketed so that end users do not have straight forward commonly used methods for access to

remove the module so that the FCC ID of the module is visible; then an additional permanent label referring to

the enclosed module Contains Transmitter Module FCC ID: UDV-201607 or Contains UDV-201607 must be used.